Low alloy steels are widely used to produce pipes, automotive and aerospace bodies, railway lines and offshore and onshore structural engineering plates. High-strength low alloy steel is used due to its corrosion resistance properties. Low alloy steels typically contain less than 10% alloying elements (C, Mn, Cr, Ni, Mo, V and Si combined). Accurate and fast elemental analysis is a critical requirement during the production of steel.

Expertise program for XRF analysis of low alloy steels

The Low Alloy Steel (LAS) Expertise program delivers a complete methodology from sample preparation to quality assurance for elemental analysis using XRF and covers high-strength low alloys, high heat resistance steels (chromium-molybdenum steel), low temperature use steels, (nickel steels), weathering steels and high tensile strength steels. The method has been developed using a master calibration of more than 90 certified reference materials.

The following elements and concentration ranges are covered:

Element Concentration range (wt%) Element Concentration range (wt%) 
C< LLD - 1.29Cu0.0013 - 0.66
Al< LLD - 0.3As0.0005 - 0.14
Si< LLD - 1.46Zr0.0015 - 0.2
P0.002 - 0.072Nb0.0004 - 0.3
S0.0009 - 0.089Mo0.002 - 1
Ti0.0005 - 0.31Sn0.001 - 0.24
V0.0006 - 0.52Sb0.0005 - 0.072
Cr0.0015 - 5.15Ta0.001 - 0.23
Mn0.0057 - 2W0.012 - 0.3
Co0.0012 - 0.3Pb< LLD - 0.024
Ni0.002 - 4.45

Note: If the certified concentration is lower than the LLD value, the term < LLD has been used to indicate the lower limit of the concentration range

This Expertise program includes a complete methodology, from sample preparation to quality assurance, to be used with Malvern Panalytical’s XRF systems.

Included

  • 4 monitor samples for drift correction and sample preparation correction, together with method setup templates
  • Setup of optimized analysis program and system calibration using 6 transfer samples traceable to more than 90 CRMs, enabling best throughput and accurate results, as well as easy routine analysis by factory operators
  • Setup of calibration maintenance procedure
  • Advice on workflow optimization
  • Advice on efficient preparation of samples
  • User training and documentation

NOTE: transfer samples will be made available for calibration, these samples are to be returned to Malvern Panalytical.

Optional

  • Statistical Process Control for WD XRF systems*, for setting up QA/QC workflows

Prerequisites

  • Malvern Panalytical XRF spectrometer: ZetiumAxios, or MagiX WD XRF systems
  • Sample preparation equipment

Contact our specialists

SPC is already included with Zetium systems