Analysis of iron sinter by X-ray diffraction reduces CO2 emissions

In this data sheet we show typical results of the analysis of Fe2+ (FeO), basicity and phase composition.

Iron sinter is an important feedstock material for the steel industry. Due to increased quality requirements and the need to reduce energy consumption and CO2 emissions, the phase composition and chemistry of iron sinter need to be analyzed fast and precisely. The fuel consumption per ton iron ore sinter is approximately 60 kg coke. A small fuel saving due to improved process control already represents a significant saving in energy and costs. 

Aeris Metals edition

Introduction

Iron sinter is an important feedstock material for the steel industry. Due to increased quality requirements and the need to reduce energy consumption and CO2 emissions, the phase composition and chemistry of iron sinter need to be analyzed fast and precisely. The fuel consumption per ton iron ore sinter is approximately 60 kg coke. A small fuel saving due to improved process control already represents a significant saving in energy and costs.

X-ray diffraction (XRD) is a fast and cost-effective method for the analysis of process-relevant parameters during the production of iron sinter. The Metals edition of Aeris is the first benchtop X-ray diffractometer that is designed for process control in the iron and steel production. In this data sheet we show typical results of the analysis of Fe2+ (FeO), basicity and phase composition.

Experimental

In order to show the capabilities of the Metals edition of Aeris, several samples from different stages of the iron sinter production were analyzed. The presented data were mea- sured using cobalt radiation, which is especially suited for materials with high iron contents, as it produces high-resolu- tion data. The measurement time was 5 minutes per sample, followed by data processing and evaluation.

Result and discussion

A total of 48 individual sinter samples with Fe O values ranging from 5 to 9.3 wt.% and a basicity (CaO/SiO2) between 1.5 and 1.7 were analyzed by Aeris using XRD in combination with a fully automated Rietveld refinement and partial least squares regression (PLSR). In addition to the phase composition including the amorphous fraction, the FeO content as well as the basicity were obtained from the same 5 minute scan of each sample (Figure 1).

The comparison of the provided values with independently determined reference values of FeO (wet chemistry) and basicity (X-ray fluorescence) shows very good agreement. Even small variations in the process parameters can be identified allowing a very effective screening of the sintering process (Figure 2a).

The repeatability of the analysis was tested by performing 50 individual measurements of a sinter sample and repeatedly running the automated analysis. The result shows that the analysis is stable and reliable with estimated standard deviations (3σ) of 0.168 wt.% and 0.009 for FeO and the basicity, respectively (Figure 2b).

image1.PNG

Figure 1. XRD refinement showing full phase characterization of a Fe-sinter measurement scan 

figure1.PNG

Figure 2. (a) Comparison of FeO and basicity obtained by XRD with independent reference values. (b) Repeatability of the automated XRD analysis procedure 

figure2.PNG

Conclusions

The presented results show that the Metals edition of the Aeris benchtop X-ray diffractometer is a fast and reliable tool to determine FeO, basicity and other process-relevant parameters for the production of iron sinter. Accurate determination of phase composition (including the amorphous fraction) and process parameters contribute to an improvement of the process, with the ultimate benefit of reducing energy consumption and CO2 emissions.

Einloggen

Not registered yet? Konto erstellen