• Ensure all vials to be attached to the Archimedes instrument are polymer-coated (Order RMM0005 from Malvern Panalytical Helpdesk for a box of 24 or contact your local Malvern Panalytical representative). These polymer-coated vials have a mottled polymer coating rather than a clear finish and provide enhanced user safety in the unlikely event of a latent defect in the vial causing a breakage.
• Before use, clean all vials with glass cleaning detergent, ensuring to remove all residue with ultra-pure water. Leave vials upside-down to prevent dust settling inside the vials while drying.
• Ensure liquid-containing vials are only filled to three quarters of their capacity.
|Solution Required||Part Number||Function||Preparation Procedure|
|Standard for Micro Sensors (Serial Number: A----H)||RMM0003||Size calibration of Micro sensors||Sonicate and dilute ~1 µm polystyrene latex in ultra-pure water to approximately 107 particles/ml|
|Standard for Nano Sensors (Serial Number: D----E)||RMM0004||Size calibration of Nano sensors||Sonicate and dilute ~500 nm polystyrene latex in ultra-pure water to approximately 108 particles/ml|
|100% D2O||RMM0008||Calculation of instrument bulk sensitivity||Ensure vial is completely dry before adding D2O|
|Reference Solution||RMM0011||Sneeze profile visualization||Dilute 1ml of 100% D2O in 14ml of ultra-pure water|
Waste vials should be empty
Screw vials into the vial ports as indicated in Figure 1.Fig.1 Vial positions for Archimedes instrument setup
If assistance is required in the setup or use of the Archimedes, please contact your local Malvern Panalytical representative or contact the helpdesk.
Other Basic Guides for Archimedes systems for resonance mass measurements are available:
Making a resonance mass measurement